LPWCO method for the treatment of high concentrated organic wastewater

Based on wet air oxidation (WAO) and Fenton reagent, thispaper raises a new low pressure wet catalytic oxidation(LPWCO)which requires low pressure for the treatment of highlyconcentrated and refractory organic wastewater. Compared withgeneral wet air oxidation, the pressure of the treatment(0.1-0.6MPa) is only one of tens to percentage of latter(3.5-10MPa). Inaddition, its temperature is no more than 180℃.Compared withFenton reagent, while H2O2/COD(weight ratio) less than 1.2, theremoval of COD in the treatment is over twenty percents more thanFenton's even the value of COD is more than 14000mg/L. In thispaper, we study the effect factor of COD removal and the mechanismof this treatment. The existence of synergistic effect (catalytic oxidation and carbonization) for COD removal in H2SO4-Fenton reagent system under the condition of applied pressure and heating (0.1-0.6MPa, 104-165℃) was verified. The best condition of this disposal are as follows:H2O2/COD(weight ratio)=0.2-1.0, Fe2+ 0.6×10-3 mol, H2SO4 0.5mol, COD>1×104mg/L, the operating pressure is 0.1-0.6MPa and temperature is 104-165℃. This method suit to dispose the high-concentrated refractory wastewater, especially to the wastewater containing H2SO produced in the manufacture of pesticide, dyestuff and petrochemical works.     

武汉东湖湖水的藻类生长潜力(AGP)测试

在东湖湖水样品中添加排入东湖的主要污水或营养物(氮和磷)进行藻类测试,观察它们对斜生橱藻(Scenedesmus obliquus)的生长促进作用.生长反应与添加的污水浓度成正比,其SC_(20)(促进20％增长的浓度)为0.5—4％.单独添加氮或磷,在高浓度情况下也很少促进藻类生长,但共同添加时大多有促进作用.东湖为一严重富营养型湖泊,为了控制其富营养化进程,污水截流应是首先要采取的一项措施.     

高浓度废水预处理

从分析冲击炼油污水处理的原因出发，阐述了高浓度废水预处理的重要性；重点介绍了三种好氧生物法处理技术；其中ＳＢＲ法由于工程技术日趋成熟，可优先推广应用     

含柠檬酸盐电镀废水的处理

对含柠檬酸盐电镀废水的几种处理方法的比较表明,氯化钡添加法能较好地使柠檬酸盐沉淀,操作简便,处理效果理想,其柠檬酸根离子的去除率达98％以上。     

高浓度印染废水处理工程工艺条件与实例分析

研究以三相生物流化床作为工程化反应器处理印染废水的工程工艺条件及操作特性，分别测定流化床内的气相含率，兴体循环速度及体积氧传质系数。     

石油亚砜萃取巯基醋酸的研究

对石油亚砜(PSO)萃取巯基醋酸的条件和影响进行了实验研究,确定了石油亚砜通过氢键和巯基醋酸形成的萃合物的组成.为从废水中回收巯基醋酸以及石油硫醚的综合利用提供了依据.     

AT－SS复合颗粒吸附剂的制备和除铅性能研究

通过颗粒吸附剂在含铅溶液中的振荡实验．研究了凹凸棒石粘土（ＡＴ）和钢渣（ＣＳ）、水泥（ＳＮ）、石英砂（ＳＳ）制得的多种复合颗粒吸附剂的除铅性能及制备条件．确定出最佳颗粒吸附剂为ＡＴ－ＳＳ，混合比为５：１，７００℃下焙烧１２０ｍｉｎ．对铅的静态吸附容量高达５００ｍｇ／ｇ以上，动态吸附容量为６０ｍｇ／ｇ．在１．５ｍｌ／ｍｉｎ的流速下，穿透时间为２０ｈ，洗脱回收率为４８．３％．当Ｐｂ进样量为２００ｍｇ／Ｌ时，ＡＴ－ＳＳ吸附剂在２３６倍床体积之内，流出液浓度低于排放标准．     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

高级氧化技术机理及在水处理中的应用进展

综述了近年来发展迅速的高级氧化技术，主要包括Fenton法、臭氧氧化法、湿式氧化技术、超临界水氧化法、纳米光催化氧化法电化学催化降解法及超声降解法等。介绍了各种高级氧化技术的基本原理及在废水处理中的应用进展，并对其特点进行了评述。     

微电解-水解酸化/接触氧化工艺处理染化废水的研究

采用微电 解 Ｈ／ Ｏ 工艺对染 料化 工 废水 进行 了 处理 研究 ，结 果表 明 以微 电解 和 水解 酸 化作预处理 ，可使废 水的 Ｂ Ｏ Ｄ５／ Ｃ Ｏ Ｄ Ｃｒ 的比由 ０２５ 提高 到０５ ０ 左 右，平 均 增加 ５０ ％ 。通 过加 酸， 可提高微电 解的去除 效果，在 进水 Ｃ Ｏ Ｄ Ｃｒ 为４ １００ ～４ ３００ ｍ ｇ／ Ｌ，色度 为３ ４００ ～３ ６００（ 倍） 范围内 ，系统对 Ｃ Ｏ Ｄ Ｃｒ 和色度 的去除效 果分别 可达到９７ ５ ％ 和９８３ ％